Skip to content
Sectors

Pure Water Systems for Pharmaceuticals and Cosmetics

Product-ingredient water prepared with reverse osmosis and EDI, with microbiological control on the distribution loop and traceable operation.

In pharmaceutical and cosmetic production water is not an auxiliary input; in most products it is the largest ingredient. The quality of the water used in formulation, equipment washing and final rinsing passes directly into the product and is subject to inspection. The purity targeted is therefore higher than in most industrial processes; alongside chemical purity, microbiological quality is expected, together with records showing that this quality is held the same every day.

For pharmacopoeia classes such as purified water, the target quality and the monitoring plan are set in the project according to the relevant pharmacopoeia (Ph. Eur., USP). In cosmetics the expectation depends on the product type and on the company’s quality system. In both cases we start with a raw water analysis and a site inspection, and design production, storage and distribution as a single system, because quality is more often lost on the distribution loop than in the production unit.

Where water is used

The decisive quality

  • Formulation water

    In creams, lotions, syrups and solutions the water goes into the product. The decisive parameters are conductivity, total organic carbon and microbiological load. In cosmetics the microbiological load of the water also sets the burden placed on the product’s preservative system. Quality at the point of use is therefore as important as quality at the outlet of the production unit.

  • Washing and final rinse

    In cleaning reactors, tanks and filling lines, the final rinse must leave no residue on the surface. Its quality is chosen to be consistent with the water used in the product; conductivity and microbiological quality are part of cleaning validation. Because washing programmes draw sudden peaks of demand during the day, the storage tank is sized to meet them.

  • Quality control laboratory

    Water used in analyses and for preparing solutions directly affects the measurement result. What is decisive here is the stability of conductivity and organic load; the need is usually met with a separate polishing stage. Even though consumption is small, water must be available at all times and its quality recorded regularly.

  • Steam and utilities

    The boiler that produces steam for sterilisation and heating also needs its own feedwater. Hardness and conductivity are decisive here; in applications that require clean steam, the target quality is again set in the project according to the relevant pharmacopoeia.

Work out your line in a few steps

The solution finder opens with this sector selected; choose your water source and goal and it shows the treatment stages that fit.

Try the solution finder →

Frequently asked questions

How is purified water produced in the pharmaceutical industry?

The common arrangement is filtration, activated carbon and softening followed by double-pass reverse osmosis and EDI. The product water is collected in a storage tank and delivered to the points of use through a continuously circulating distribution loop. The target quality, sampling points and monitoring plan are set in the project according to the relevant pharmacopoeia; the details of the arrangement depend on the raw water analysis.

How is bacterial growth prevented in a pure water distribution loop?

Dead zones where water stands and low flow are the main causes of bacterial growth and biofilm. The loop is therefore built for continuous circulation, dead legs are avoided, and a disinfection stage such as UV or ozone is planned on the loop together with periodic thermal or chemical sanitisation. The method is chosen in the project together with the pipe material and the operating temperature.

What water quality does cosmetics production require?

In cosmetics a single pharmacopoeia class, as in pharmaceuticals, may not be mandatory; the expectation varies with the product type, the target market and the company’s quality system. Most production uses water treated by reverse osmosis and microbiologically controlled, with polishing by EDI or mixed bed added for sensitive products. We set the target together with your quality team.

Send us your raw water analysis and the flow rate you need

Let us size the system together; we will survey the site in person if needed.